Rat Rig Community [Unofficial]•4d ago

Finish the Commissioning guide

I tried to change into the performance mode, but I can't save the changes. I think it is because both toolheads have warnings ...

Solution:

Then you should be fine

Jump to solution

11 Replies

Catweazle (Stefan)OP•4d ago

I found how to save the changes but still don't understand the warning

TheTik•4d ago

Are your thermistors reading sane temperatures?

Catweazle (Stefan)OP•4d ago

I did the PID for both hotends an everything worked ok

Solution

TheTik•4d ago

Then you should be fine

Catweazle (Stefan)OP•4d ago

... as far as I could see

Catweazle (Stefan)OP•4d ago

Next Error message:

Catweazle (Stefan)OP•4d ago

in which cfg can I find this option? I can't find it - I find it just in the klippy.log

Catweazle (Stefan)OP•4d ago

TheTik•4d ago

Sounds like you may not have updated ratos Try this, starting from step 4 since you've already run through the configurator:

1. Flash image
2. Connect to hotspot
3. Setup wifi through configurator (and let it reboot)
4. Go to /config
5. Refresh update manager
6. at this point nothing should be invalid, all green. IF THAT'S NOT THE CASE stop here and post your moonraker.log
7. Update only the RatOS package(NOT configurator).
8. Update RatOS configurator (this takes awhile, if the mainsail output of the update process hangs, let it sit for 10 minutes and then refresh the page, Ctrl+Shift+R)
9. Restart moonraker service (click power icon in the top right of mainsail, click the refresh button next to moonraker under "service controls")
10. Reload mainsail (Ctrol+Shift+R)
11. Refresh update manager
12. "RatOS" should be gone from the list. Everything should be green and have several updates except RatOS configurator (ignore the klipper errors). If it's not, stop here and post your moonraker.log.
13. Click update all.
14. Done.

1. Flash image
2. Connect to hotspot
3. Setup wifi through configurator (and let it reboot)
4. Go to /config
5. Refresh update manager
6. at this point nothing should be invalid, all green. IF THAT'S NOT THE CASE stop here and post your moonraker.log
7. Update only the RatOS package(NOT configurator).
8. Update RatOS configurator (this takes awhile, if the mainsail output of the update process hangs, let it sit for 10 minutes and then refresh the page, Ctrl+Shift+R)
9. Restart moonraker service (click power icon in the top right of mainsail, click the refresh button next to moonraker under "service controls")
10. Reload mainsail (Ctrol+Shift+R)
11. Refresh update manager
12. "RatOS" should be gone from the list. Everything should be green and have several updates except RatOS configurator (ignore the klipper errors). If it's not, stop here and post your moonraker.log.
13. Click update all.
14. Done.

Catweazle (Stefan)OP•4d ago

moonraker4.log

Gaming

Programming

Finish the Commissioning guide

Did you find this page helpful?