Catweazle (Stefan)
RRCRat Rig Community [Unofficial]
•Created by Catweazle (Stefan) on 5/14/2025 in #ratos-support
Vcore 4 400 IDEX - Z-Offset
2 replies
RRCRat Rig Community [Unofficial]
•Created by Catweazle (Stefan) on 5/13/2025 in #ratos-support
Orcaslicer 2.3
Unfortunately, I had to downgrade my Orca from 2.3 to 2.2 today. Is it foreseeable when 2.3 will also be supported?
5 replies
RRCRat Rig Community [Unofficial]
•Created by Catweazle (Stefan) on 5/13/2025 in #ratos-support
VAOC calibration
6 replies
RRCRat Rig Community [Unofficial]
•Created by Catweazle (Stefan) on 5/11/2025 in #ratos-support
**RatOS Configuration Repository**
16 replies
RRCRat Rig Community [Unofficial]
•Created by Catweazle (Stefan) on 5/11/2025 in #fix-my-printer
Finish the Commissioning guide
15 replies
RRCRat Rig Community [Unofficial]
•Created by Catweazle (Stefan) on 4/29/2025 in #fix-my-printer
beacon_initial_calibration issue
Now I have the next problem:
While proceeding the homing sequence with beacon_initial_calibration the printer first homes Y (ok) - the X-Axis moves back and rests in the middle - then X T0 (ok) and X T1 (ok).
Both toolheads rest on their oozeguard parts. When now the bed is homing, it moves upwards, but can't get in contact with the beacon module as it rests "outside". So the motors now chatter on the top ...
As I read in another post, T0 should move in the middle of the printbed, but it doesn't on my printer
What do I make wrong?
10 replies
RRCRat Rig Community [Unofficial]
•Created by Catweazle (Stefan) on 4/29/2025 in #fix-my-printer
homing z
9 replies