![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
G28 Internal Error On new Install
So having a similar issue with a fresh install using 2.02. At first I struggled with my SKR2 459 board firmware not matching even though I compiled new and loaded. This eventually got worked out in Kilpper and no more errors showing (though it still shows the issue running in the configure setup wizard).
When I home or even move the head I get the "internal error on command G28". However if I use the "Set center kinematic position" I was able to home and run a print no issues. But after it just went back to same problem and error.
Any ideas what may be going on? I attached, printer.cfg, klippylog and Debug but not sure exactly how to grab that one so just zipped a txt file.
Thanks
When I home or even move the head I get the "internal error on command G28". However if I use the "Set center kinematic position" I was able to home and run a print no issues. But after it just went back to same problem and error.
Any ideas what may be going on? I attached, printer.cfg, klippylog and Debug but not sure exactly how to grab that one so just zipped a txt file.
Thanks
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}