Ratos Configuator update gets stuck at 91% -93%
I am trying to commission my Vcore4 and when I try to update ratos configuator it will not complete and gets tuck at 93%. When I refresh the update will complete and everything else updates ok. Then when I try to flash my board in DFU the board isn't detected. I have tried 3 Pi's, 4 new SD cards and 2O Octopus v1.1 boards all with the same result. I have also tried to flash it with a SD card with the compiled firmware and I still get board not detected. Any help with this would be very much appreciated. THis my second rta Rig
5 Replies
If you just refresh the webpage it doesn't show that it's still going? Or done?
It can take 5-10min
It shows that the update was successful.
I waited over 1 hour with the same result.
I installed the DFU jumper then press reset while the power was on. I am wondering if my prcedure was wrong.
I haven't personally used DFU, have only used the sd card to update the octopus
I disconnected as indicated