how to make nuxt 3 reproduction?
How do i create a basic nuxt 3 reproduction where i install nuxt-security and nuxt-emoji picker?
3 Replies
Hi @WiFi Plug. I'm kapa.ai, your friendly support bot. I will try to answer your question by searching through the knowledge base. :wave:
----------------------
To create a basic Nuxt 3 reproduction, you need to set up a new Nuxt 3 project and install the desired modules. Here’s how you can do it based on the official documentation:
1. Create a New Nuxt 3 Project
Open your terminal and run:
Replace
The knowledge sources do not provide specific details about the
<project-name>
with your preferred directory name. This will scaffold a new Nuxt 3 project and install its dependencies Nuxt Installation Guide.
2. Install Additional Modules
To add modules like nuxt-security
and nuxt-emoji-picker
, run:
If you use3. Register the Modules Edit yourpnpm
,yarn
, orbun
, use the corresponding command as shown in the Nuxt docs.
nuxt.config.ts
to include the modules:
4. Start the Development Server
Run the development server:
This will start your Nuxt 3 app at <http://localhost:3000
> Nuxt 3 Minimal Starter.
---
Note:The knowledge sources do not provide specific details about the
nuxt-security
or nuxt-emoji-picker
modules, but the general process for creating a Nuxt 3 reproduction and installing modules is as described above. If you need to share your reproduction, you can push your project to a GitHub repository or use an online sandbox as suggested in the Nuxt documentation Nuxt Installation Guide.
----------------------
Note: you can ask me a follow up question by @ mentioning me again :speech_balloon:
----------------------<@679734274840330384> Kapa.ai is still learning and improving, please let me know how I did by reacting below.
Just use https://nuxt.new
nuxt.new
Kickstart your Nuxt project