26 Replies
Need way more info. What are you trying to do? When does the error happen? Is this a new setup or have you been printing successfully and this suddenly started happening? What have you tried?
just trying to setup my vaoc for intial calibration
tried everything and dont know what to change in the cfg to where i feel safe about it so kinda scared but know what to do i felll but lost
Are you using the commissioning guide?
yes
What step are you on? What do you expect to happen?
essentially get the error of the postion too far when trying to save the vaoc calibration or prior to it doing adjusting the nozzle get the error
Again, what step are you on?
Were you able to home the machine? And run z-tilt?
yea
i can send you my print cfg
What happened when you ran
_vaoc_reset?same issue
so at what point did the error occur the first time?
essentially once saving the vaoc calibration now it wont do the vaoc calibration without the error
Did you try expanding this section?
yup doesnt work
what did you try
how can i get all new files
reflash sd card with ratos
do i have to takew off the toolboardss for t1 t0 and the pi
nah
how do i do it then
how do you write to an sd card?
Tell me all star haha
your questions have no content. They are impossible to answer. Give as much information as you can about your problem and people will have a much easier time and spend less energy trying to help.
This page in general is more about software issues, but this section may be helpful to you in the future. Best of luck.
http://catb.org/~esr/faqs/smart-questions.html#beprecise
Your completely wrong but no worries take care as well