Vaoc off by ~100 mm
What’s up, guys
I was wondering if someone could help me,
When I try to calibrate the VAOC it’s off by like 100 mm, (see picture is the t1) can’t even get the camera anywhere close to the nozzle
Is the 400, I’m wondering if anyone has any ideas at all?
Solution:Jump to solution
ive calibrated vaoc by move the tool head a litte at a time, dc_endstop, put that into printer cfg, and have successful prints, thanks everyone
4 Replies
FWIW another User I was trying to help today had a similar issue
where the VAOC was correct for T0
but T1 started off 25mm out
when using DC_offset_Calibrate
it assumes something like 533mm for an endstop-location for T1,
which means that 0,0 on T1 stops 20mm from the edge of the build plate
its very odd
@Markus123 can you post a picture of your variables
Dumb question, but where is your Y endstop located? I ran into an issue where it was putting the tool head too far behind the build plate. Found out I put the endstop in the wrong location.
Solution
ive calibrated vaoc by move the tool head a litte at a time, dc_endstop, put that into printer cfg, and have successful prints, thanks everyone