Smart Sensor detects filament - RatOs doesn't get the information
It is a vcore4 using Orbiter V2 Smart Sensor. RatOs v2.1.0-RC3
The Smart Sensor detects the filament, the LED turns green. But RatOs seems not to pick up this information.
It is a actual shipped setup with the EBB42 CAN V1.2 toolboards.
Solution:
Jump to solution
Ok the issue is solved: it had been a wiring issue and changed the Filament and the Button wire. As you get suspicios with the current documentation I looked at the pins from the official Orbiter Website. But they got it wrong. The RatRig documentation is correct.
5 Replies
Can you clarify the error or problem?
One thing I see is your config has "Pause_on_runout: False" where you probably want that to be true (pause if it runs out of filament). But not sure if that's what you are reporting.
One thing I see is your config has "Pause_on_runout: False" where you probably want that to be true (pause if it runs out of filament). But not sure if that's what you are reporting.
I also head seen that "Pause_on_runout: False" but thought it is the file as it is when following RatRigs Commissioning guide. But would't that mean if you had loaded fillament and run out that the print doesn't stop?
I load the filament via macro:
the console shows it's loaded
In the dashboard the sensor shows "empty"
After starting the print I receive the error:
Solution
Ok the issue is solved: it had been a wiring issue and changed the Filament and the Button wire. As you get suspicios with the current documentation I looked at the pins from the official Orbiter Website. But they got it wrong. The RatRig documentation is correct.