OrcaSlicer Retract Settings not handed over to RatOS??
Hi all,
I use OrcaSlicer and I set the Retract settings within the Printer Settings and only partially use the Filament Override section. I now realized that the RatOS Dashboard always shows me the retraction speed of 60 but in the Orcas Settings its set to 100. Same with the retract length.
Am I doing something wrong or is it some kind of an issue with orca that I wasnt aware of? Or is the information handed over and simly doesn´t show it?
I am confused, hope somebody can bring the light 🔦
best regards
1 Reply
those come from the various firmware_retract sections in things like your extruder and hotend config files or even in your printer.cfg if you've overridden it. These only apply if you turn on Firmware retraction in your slicer in which case instead of standard extruder move commands based on the retraction settings for the printer it uses G10/G11 codes which mean use the firmware_retraction values