how do you configure exclusion zones for mandala bed with embedded magnets??
I am trying to get through comissioning process on a printer with the mandala bed with embedded magnets, but Im not sure Im clear on exactly how this is done. I see how it's referenced in Klipper docs to set htis up, but when I checkout the printer.cfg on the machine, there is no section for
[bed_mesh] I do see a bunch of stuff that is commented out rerring to bed mesh settings, but has a big warning "DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated." Somewhat confused and stuck on where to go. I checked out other configuration files but didn't see any bed mesh entries is those either. Any guidance here? Or an example printer.cfg possibly?1 Reply
I was able to figure out what was going on here and someone shared a perfect config. I guess just needed the
[bedmesh] entry and it was ready to go.