stepper_x1 failed to init
I get this error message during commissioning, I checked and rechecked my wiring and all my X motor cables are correctly installed
Board is BTT Octopus v1.1 F446, Hybrid build, I have the ratrig configuration followed with my parts, so nothing extra or changed
Also tried shifting the stepper drivers around (2209) to see if that fixed it, it did not change anything
I have also gone through the initial setup configurator, and started following the steps in commissioning
Any suggestions on what to check next?
Thanks in advance!
4 Replies
Try swapping motors around? Can just do it at the connector, don't need to physically move the motor.
See if the issue moves
I tried swap the X motor cables around, even tried with the Z driver motor cables, did not help, also tried again to swap around the drivers, did not solve either 😦
I have now solved this, for anybody else that might have this problem, try swap out all of your jumpers under the tmc drivers, one of mine was bad, it now works, totally insane
Oh wow, that's crazy. A few months ago there was someone else in here that had a broken jumper. Never heard of it before that and now it's been twice!
yeah, I was on my way to swap the board for another spare one, but I just did this as a final thing cause I remembered from the old time with mechanical IDE harddrives, jumpers could be bad