Strange behaviour of my printer after reloading a spool (vcore 4 idex sprinting like hell)
Hey guys,
i need your help solving a strange issue with my printer.
Setup:
vCore 4 500 IDEX with a smart sensor attached, printing PLA with a 0,8mm Nozzle - max flow 23mm³/s
what happened?
0. The loaded spool was ampty and i pased the printer over the klipper screen.
1. unload filament over klipperscreen macro (unchanged to ratOS)
2. loading the new spool over the load macro (also unchanged)
3. resume print.
the printer then moved to the point where i paused the printer. the nozzle heated up to 230°C and after reaching the temperature, the printer continued printing with a speed of 600mm/s.
Then I stopped the printer over pause macro and used the web interface in order to cut out any issue over klipper screen. I used the macro Load Filament and resumed the print again. same behaviour.
watch the video: https://discord.com/channels/582187371529764864/851109908849491968/1404082174533308578
the 1st thing i have no answer to is: *why the heck is the nozzle heating up while it was already resumed? *
the 2nd question: why does the printer continues with 600 mm/s? (the travelspeed is 600, max speed set on klipper is 800)
0 Replies