Suddenly heater bed not heating at expected rate while printing, log shows no abnormalities
Hi everyone, my V-Core 4 shut down mid print due to error described in title. The klippy log shows nothing unusual, the temperatures logged right before the error show exactly the expected temperature. Please take a look at the screenshots of the log, full log is attached too. The thermal fuse is alright, the bed heats just as expected after restart.
It's really annoying when you're in the middle of a day long IDEX multi material print and it just shuts down... If anyone has an idea what could cause this, I'd be very glad.
2 Replies
I can't really read into the logs too much. But I would suspect a bad thermistor. Try measuring the resistance on the thermistor and see what it says. It should read around 100k ohm.
they said it heats normally after the fact
But it may have been wiggled or something during the print. @NotoriousEagle Try heating it up then wiggling wires, see if you can get some wonky readings.