![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Control board flashing
Setting up my IDEX 500 and stuck on flashing the Control board.
I have other printers on ratOS2.0 but this is my first time on 2.1 and getting stuck at board not detected.
I have everything plugged out, The Pi is powered through the Octopus as per the doc's and a Usb C to USB A to the PI.
Tried DFU to no avail and then tried SD card but it doesn't change to .cur as you'd normally expect.
I have the jumper removed from the USB power on the Octopus.
I'm at a loss and feel like I'm missing something here.
any help appreciated.
I have other printers on ratOS2.0 but this is my first time on 2.1 and getting stuck at board not detected.
I have everything plugged out, The Pi is powered through the Octopus as per the doc's and a Usb C to USB A to the PI.
Tried DFU to no avail and then tried SD card but it doesn't change to .cur as you'd normally expect.
I have the jumper removed from the USB power on the Octopus.
I'm at a loss and feel like I'm missing something here.
any help appreciated.
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}