"Listen" to Elgato HD60X in Bazzite
I've got a more of a personalised question. I'm running the HD60X through my PC for streaming my Xbox Series X (XSX). While gaming I have the the XSX through my HD60X in "Listen to this device" so I can 1 hear what's going to stream and 2 for when I want to play off stream I can just hear it without changing headphones. So far I found that you can use Pulse Audio to enable Loopback with this command "pacmd load-module module-loopback latency_msec=1" but I'm wondering if there is a better way to run the same style as before or a way of running pulse audio with the command on start up to allow passive audio.
Update: I have it working on Audiopulse and set it up so it starts on start-up. It's not remembering any settings/commands that were set previously which is rather annoying. Also found that since OBS uses audiopulse for it's audio capture if I open OBS (either accidentally or deliberately) it will kill the audio from the Elgato until I kill both processes and essentially start again with more resets.
Solution:Jump to solution
Ended up just opening OBS in the background when I change between Xbox and Bazzite
3 Replies
What streaming tool you are using?
OBS when I stream
Update: I have it working on Audiopulse and set it up so it starts on start-up. It's not remembering any settings/commands that were set previously which is rather annoying. Also found that since OBS uses audiopulse for it's audio capture if I open OBS (either accidentally or deliberately) it will kill the audio from the Elgato until I kill both processes and essentially start again with more resets.
Solution
Ended up just opening OBS in the background when I change between Xbox and Bazzite