Ratos support for simplify3D
Hello all, so I worked on a print temp tower on simplify3D. When attempting to print , ratos advised that this isn’t a suggested or rather a supported slicer, to use the supported slicers. Is their anyway I can use simplify3D or am I SOL?
Solution:Jump to solution
You have to add this to the printer.cfg [ratos]
allow_unsupported_slicer_versions: True
bypass_post_processing: True...
2 Replies
Solution
You have to add this to the printer.cfg [ratos]
allow_unsupported_slicer_versions: True
bypass_post_processing: True
I had the same issue