![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Using Part Cooling Fan turns Controller Fans off
Well it's been a long while since I got into 3D Printing but here I go again finally finishing my "new" printer!
Whenever I set the PWM on my part cooling higher than 0% it will cause my controller fans to turn off if they're spinning. Besides that my Part Cooling Fan doesn't even respond to any PWM % and will not spin at all.
I'm using a Octopus Pro 446 V1.1
The Controller Fans are two 120mm Noctua's (NF-P12 Redux)
The part cooling fan is the Sanyo Denki 9GAX0412P3S001
There's a Toolboard but the fans are wired to the Octopus Pro
What could I be doing wrong to have this happen, and would could be done to fix both the part fan not responding and the control fans turning off if there's part fan PWM?
Whenever I set the PWM on my part cooling higher than 0% it will cause my controller fans to turn off if they're spinning. Besides that my Part Cooling Fan doesn't even respond to any PWM % and will not spin at all.
I'm using a Octopus Pro 446 V1.1
The Controller Fans are two 120mm Noctua's (NF-P12 Redux)
The part cooling fan is the Sanyo Denki 9GAX0412P3S001
There's a Toolboard but the fans are wired to the Octopus Pro
What could I be doing wrong to have this happen, and would could be done to fix both the part fan not responding and the control fans turning off if there's part fan PWM?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}