![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Print adhesion fails
I can't figure out why my adhesion fails just in one corner. It goes down just fine at first but then begins lifting. Then the probe catches it and drags it up, wrecking my first layer before I can even get the brim done. I just cleaned it with isopropyl, I just recalibrate the bed mesh, and I just lowered the Z Offset a little. I'm not sure what my issue here is. Any thoughts? Overture PETG, 70° C print bed for reference. Tried 80° also with the same results.
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}