Hello, I need your help figuring out how to properly configure the PINs of my board in User_Setup.h for the TFT_eSPI:
// ###### EDIT THE PIN NUMBERS IN THE LINES FOLLOWING TO SUIT YOUR ESP8266 SETUP ######
// For NodeMCU - use pin numbers in the form PIN_Dx where Dx is the NodeMCU pin designation #define TFT_MISO PIN_D6 // Automatically assigned with ESP8266 if not defined #define TFT_MOSI PIN_D7 // Automatically assigned with ESP8266 if not defined #define TFT_SCLK PIN_D5 // Automatically assigned with ESP8266 if not defined
#define TFT_CS PIN_D8 // Chip select control pin D8 #define TFT_DC PIN_D3 // Data Command control pin #define TFT_RST PIN_D4 // Reset pin (could connect to NodeMCU RST, see next line)
Hey guys, how are you? I'm having a problem with my infrared remote control receiver for my arduino ELEGO. It's properly connected, but the power led (the red one) isn't lighting up. How can i fix this? G - GND R - 5.0V Y - 11 pin
I thought the problem was the receiver, but what I really want to do is get the hexadecimal code from the remote control, but it's not giving me the code, and I thought it was the hardware.
I mean I use a libra pi, they are great, they do have gpio but nothing says you need to use it.I also love orange pi, and rock pi's. @Demon Lord of the Round Table
KICKPI K2B Single Board Computer Development Board, Allwinner H618 Quad Core 64 Bit Single Board Computer Up to 1.5GHz 2G LPDDR4 8G eMMC Support WiFi 5 and BT 5.2 Run Android 12.0/Ubuntu 2204
Well fyi one reason why some of the ones i sugest, is. 1 no sd card needed after first boot. 2, auto power on in power outtage. 3 chips shut down perferals for things not activly being use.