RRC[

Rat Rig Community [Unofficial]•3w ago

Danny (Loshan)

Crushed beacon

So, a stray support, got caught around the beacon and as You can see - the connector got snapped, also small microchip got yeeted out from the board. Tried to solder it back down, but failed miserably as ir so small, that I can barely see the pins. It's all fine if I need to change the beacon - sh!t happens, but if I disconnect the beacon - klipper can't start as it says mcu can't find it, but if I connect it right back it says - mcu can't connect to 'mcu'.
Any ideas if the octopus pro may be dead? Ordered new beacon, but how can I test if I need to order new board?