RRC
Rat Rig Community [Unofficial]•17mo ago
afraid-scarlet

400mm V-Core 3 - Am I being too picky with this mesh?

Probably im being too picky with this, but wanted some opinion from you guys. 1 mesh cold, 1 after heating it. Let me know what you think and if something can be done to improve it as well.
No description
No description
3 Replies
MONSOONO
MONSOONO•16mo ago
That looks fine. I wouldn't spend much more time on this unless you are running into issues.
ptegler
ptegler•16mo ago
tyipcal X gantry bowing . Search on gantry bow...LOTS of conversations and fixes. But PAM (again search) helps dramatically on less than full bed sized prints.
afraid-scarlet
afraid-scarlet•16mo ago
thanks guys...will try to take a look at the gantry bowing. I have seen PAM but not tried it yet
Want results from more Discord servers?
Add your server
More Posts
Rough print on RR Rapido hornHey folks. I just changed from a mosquito to a rapido and I'm still trying to dial this sucker in..BTT filament sensor keeps showing "empty" after a few secondsJust installed the BTT "smart filament sensor" and it seems to be working, shows up in the main dashprinter fails to detect bed upon mesh leveling " No trigger on probe after full movement "i reflashed firmware n did the installing all over, machine homes well, and z tilt works, yet upon twired print artifactsI've upgraded my rr500 to v3.1, since then I get this wired artifacts, normally a clear indicator ofWhen the filling space is very small, the performance is very poor. How to solve which parameter neeWell damn....after enclosure 2.0Anyone remmeber which side I need to pull and such?Buldge on multiple parts on the same printI did a multiple part print, that somehow is getting buldges on some heights, and i have no idea whaV-Core 500 3.0 -- 3.1 Upgrade WoesBeware of generic kits claiming to be V-Core 3.0 -> 3.1 upgrades. The joiner plates were for a 3.0 e