Bed mesh doesnt match up. doesnt compensate right
Having big problems with my mesh. i dont think the mesh looks bad tbh. but my results are horrible
The offset is to high in the lower right corner at the last picture, i adjusted that during the print as u see. everything after that is how it looks like when i print
10 Replies
I have the same issue
national-gold•3y ago
have you sorted it?
xenial-black•3y ago
Did you solve it?
updated to RatOS 2.0 and it seem like it solved the problem
fair-rose•3y ago
mine started doing this when I updated to 2.0
I cant figure out what is happening. the printer is compensating, just not enough
I just discovered the same issue. I believe bed mesh was broken by a recent update
yeah I think so too. my bed leveling is all over the place i have to adjust my z offest every other print. all that after i updated
Bed mesh is all klipper code. RatOS does nothing for mesh compensation.
99 times out of 100 this is mechanical, make sure your motor couplers are tightened and make sure you heatsoak, especially if your printer is enclosed.
Hi. How long for the heatsoak for ABS at 110C?
On a 400 i usually do 30 - 40 minutes