Very tilted v minion
What's the best way to resolve this to be a little more normal on the v minion? ABL is doing a decent job compensating but it's not ideal.
16 Replies
conscious-sapphire•3y ago
screws_tilt_calculate
This should help if you haven't done it already.generous-apricotOP•3y ago
use those values for the nuts below? The screws are covered by the magnet
conscious-sapphire•3y ago
I cut the magnet sheet to expose the screws. You need the screw heads exposed. That is the only way you will flaten the bed.
conscious-sapphire•3y ago
generous-apricotOP•3y ago
hmm interesting
not sure how easy that will be once I have it on
I might just leave it and let ABL does it's job
conscious-sapphire•3y ago
That sounds like a plan
Search for beer can method
Dort use tilt adjust
First you need to level the gantry
generous-apricotOP•3y ago
I saw that in the pins, but wasn't sure what I should loosen and tighten before and after.
The screws that hold the gantry
You must loosen the gantry
generous-apricotOP•3y ago
Is that these two screws?
generous-apricotOP•3y ago
or am I looking at the wrong ones
No
generous-apricotOP•3y ago
or the screws below that on the rail?
the screws that hold the gantry
generous-apricotOP•3y ago
OH
ok thank you I will do that tomorrow
idk why I didn't realize that 😳
Ok I trammed it and it's under 0.5mm now
still not ideal but definitly much better