![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
V3.1 Rear Z Axis -- Sufficient to Just be Parallel?
I got my rear Z axis parallel to the two front ones pretty much dead on. But the entire bar is slightly closer to the left one than the right one. But undoing the screws to scooch it closer to the right one means I have to agonize over getting it parallel again.
As I understand it though, as long as it's parallel, and it's close enough to the middle, it's fine. Because the build plate will just be rotated the faintest amount -- but since it is parallel it'll be consistent and won't matter.
Is this correct?
As I understand it though, as long as it's parallel, and it's close enough to the middle, it's fine. Because the build plate will just be rotated the faintest amount -- but since it is parallel it'll be consistent and won't matter.
Is this correct?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}