![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Problems printing PETG
Hello dear Makers
i ran into a Problem printing PETG while the test print seems fine .
I have nothing changed on my config since extruder seens calibrated.
Z height should be ok due to the test Print.
lowered the speed to 50 mm/s for the first Layer. My bed is relative flat on this part of the bed i use adaptive bed mesh.
same filament (spectrum filament lime green) on my anycubic i3 mega s looks fine.
but on the vcore 3.1 it won't print even at the same temperatures as on the i3.
Please help !! if you need some additional info i will provide them.
i ran into a Problem printing PETG while the test print seems fine .
I have nothing changed on my config since extruder seens calibrated.
Z height should be ok due to the test Print.
lowered the speed to 50 mm/s for the first Layer. My bed is relative flat on this part of the bed i use adaptive bed mesh.
same filament (spectrum filament lime green) on my anycubic i3 mega s looks fine.
but on the vcore 3.1 it won't print even at the same temperatures as on the i3.
Please help !! if you need some additional info i will provide them.
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}