Topics

Rat Rig Community [Unofficial]•9mo ago

SuperPinda

M sensor is a SuperPindaI get an error when I home Z. Endstop z still triggered after retract. In the config all it says Probe Pin and I was thinking perhaps there should be more. Any help appreciated.

4 Replies

blacksmithforlife•9mo ago

did you https://os.ratrig.com/docs/configuration#verify-endstops-and-z-probe ?

Andy•9mo ago

I homed x and y then when I tried to home z I got the error. When I refresh the endstop list it shows as z and probe triggered.

blacksmithforlife•9mo ago

read through the link I sent again - because if that is all you did you haven't verified that the z probe actually works

Andy•9mo ago

Thanks I will let you know how it goes. I have the z probe working now thank you.👍

Rat Rig Community [Unofficial]Join

12KMembers

View on Discord

Want results from more Discord servers?

Add your server

More Posts

No skew correction option for printer.cfg?I'm following the steps here: https://docs.ratrig.com/commissioning-guides/v-core-3-1#skew-calibrati Extrusion issues after retractionI'm printing a fairly large piece of plastic, and after a layer is complete, the machine will move t Belt tension checkBeing somewhat unsure of how things should look like, I would appreciate it if anybody can guide me OberflächenartefakteRiemenspannung & Inputshaper: Die schlechte Seite ist der linken Schiene zugewandt. Geschwindigkeits Batch Repair Manifold for use in OpenscadI have a larger project with around 1000 small houses from satellelite images. They are pretty broke "Ripple" on bottom and top layersI've searched for a few days, couldn't find any info on it, "bottom" layers and "top" layers have a [SOLVED] webcam not working after changing port to xxx.xxx.x.xxx:81Hello. I used to run RATOS aswell as PIHOLE on the same pi, to make this work i switched the port fo option 'pin' is not valid in section 'probe'Hi, I'm trying to set up Klipper on my new Rat Rig V-Minion but when I try to load my config I get t Problems printing PETGHello dear Makers i ran into a Problem printing PETG while the test print seems fine . I have nothin Uneven first layerHi I have a V-Core3 500 and the first layer is always uneven where some parts are much too close to