Problem Homing X and Y
Hey guys I'm trying to set up a V-Core 3 and having trouble homing X and Y.
When I initialize homing on x it sound jammed and then says - "No trigger on x after full movement"
If I then do y it gives the same error.
Any ideas on what is going wrong? I can't figure out if its a wiring/control issue or a build/mechanical problem.
Happy to send any videos for more info.
Thanks in advance
3 Replies
if you can move the carriage by hand easily to the left and right front and back (do this slowly), then likely you need to do two things, first is check your wiring for the steppers, making sure your coils are not crossed, if you are sure the coils are hooked up correctly (the stock wires if you bought a kit should be fine) then you may need to up the voltage on your steppers (but this should be the last change to do to start)
Thanks for the response. It wasn’t moving by hand so I found that the printed motor mount had a crack in it and was grabbing the belt.
glad you foun d it