RRC[

Rat Rig Community [Unofficial]•2y ago

YouvBeenThumped

Belt tension or something else?

So I'm having some slight issues, Not sure if this is belt tension related or something else.

Solution

Turns out it wasn't actually my issue... The Pi was being throttled And I didn't realize it. It was the old Motorola Phone charging brick dropping voltage. Plugged it directly into the power brick on the Surge Protector and my issue's went away.
I lifted the nozzle a whole .120 and it was still doing the same thing. And then I was also having homing issue's after I made this post. It would only move the gantry about 20mm and then stop and report no trigger after full movement.
After changing the power supply everything went back to normal, I use a .040 feeler gauge to set nozzle height since its more consistant than a piece of paper.

Jump to solution