Pitch and Roll work perfectly fine, but neither button nor hat inputs are recognized by any software. Additionally, the LED strip on top of the joystick doesn't turn on
Could you screenshot what you’re talking about? The only option the config seems to be a joystick I don’t own. Just trying to make sure I’m looking in the right place
It might affect the actual center position of the stick slightly, which could affect the games. If that’s an issue, I think you could manually adjust the upper or lower calibration values to effectively move the center position where you want it.
I’d leave it alone and roll as is. If you notice it being off center, you can adjust the calibration values manually. I doubt you could adjust it by tweaking the small pulley. It has a set screw that should only really sit in one possible position on the motor’s shaft.
It’s in the blue dot BUT not centered and not even close to me it needs like half a tooth on both sides…. I think I had one of them at 1988 but the next tooth was like 2250
the absolute encoder center position does not matter so long as the extents of a given axes are 0<4096. When you calibrate, the center will be exactly 1/2 between the endpoints. That number becomes center, not 2048.
If your stick is not perfectly centering inside the blue circle, it is likely because your grip weight plus any extension offset is dragging the stick away from center because it isn't balanced.
Use the balance force feature + adaptive recentering to counteract any imbalance in the weight distribution of the grip.
Yes (though I would caution turning it on without any grip attached, with no weight it will be quite unstable with any significant forces enabled).
The "true center" (2048) is irrelevant after calibration. The calibrated center will be 1/2 way between min/max when you calibrate. You just need the endpoints to be between 0-4096 so that the motor knows which direction the calibrated center is from whatever position it is in when you turn it on.
On the graph: Crosshairs = Calibrated Center Blue Dot = axis position Blue Circle = Spring effect center
i'll add- If, while doing calibration, one of the numbers is negative or over 4096, then you have to slip the belt off and move it a few teeth on the big gear. this diagram will get you close enough:
I was following the guide that says to do the centering tool and calibration before adding the throw limiters.
I left it as 1980’s (both axis) last night.
Now I’ll go ahead and install the throw limiters, install the boot, install the grip before I plug it in again and attempt to auto calibrate like it says in the manual.
What I did was unhook the belt and turn the motor to dead center 2048 and then attempt to add the belt but apparently 2048 is between teeth (maybe half tooth).
1 tooth on the gear is 1980’s and the next tooth over is 2200’s
I've got the Constellation Alpha now set in the configurator window (as your screenshot shows, thank you for that), but I'm still not getting any button inputs to display
Howdy everyone, is there a link to some instructions on how to replace the Rhino with the anodized thread replacement? Also, looks like I’ll need a torxhead wrench set, any other tooling?
Hi, have made my pedals mod, but having strange issue with rhino software/hardware. I can see device connected, temperature readings, current, etc. In software it says that motor x ok, but no readings are transmited (sometimes 000, sometimes - sign in value of x position)
Has anyone had an issue playing IL2 online and you get killed/destroyed or whatever, and your rino keeps sending force feedback from the last event, despite being sent back to the map to choose a new aircraft and loadout?
S
W
T
S
M
N
T
S
W
M
D
C
