![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
After Toolchange in Idex print Firmware restart
Sorry but need help: IDEX 3.1 Manta M8P with EBB42 - RatOS 2.1. When i print with T0 standalone - everything works fine. When i print with T1 standalone everything works fine. When i make multicolorprint - after first switching to T1 it does purging and then start printing T1 - after a few sec rattling of extruder T1 lgx Lite Extruder gear (seems to overextrude) and klipper shutdown with
MCU 'toolboard_t1' shutdown: Rescheduled timer in the past
This generally occurs when the micro-controller has been
requested to step at a rate higher than it is capable of
obtaining.
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
Sliced with SS (also the working standalone T0 and T1 prints) - what might be here the problem? Any suggestions?
Wrong Toolchange gcode in superslicer can cause this?
MCU 'toolboard_t1' shutdown: Rescheduled timer in the past
This generally occurs when the micro-controller has been
requested to step at a rate higher than it is capable of
obtaining.
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
Sliced with SS (also the working standalone T0 and T1 prints) - what might be here the problem? Any suggestions?
Wrong Toolchange gcode in superslicer can cause this?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}