hello, i cannot adjust the max value any higher than 65535
hello, i cannot adjust the max value any higher than 65535
MI am unable to do what you are suggesting
Pthen try -65536 on minimum
Mi am unable to enter any negatives
Mthe - keys (both of them, number pad and above letters next to backspace ) do not allow input unto the box
Pwhat happened when you try calibration?
Mit will pick numbers
Mand i can max min it, but still when twisting the axis, the counter rolls over
Mit counts multiple times greater than 65536
Mso even if i can center it
Pbut your Z axis value indicates already negative
Myes
Mmy raw center value is 14885. if i twist it to the left, immediately counts up, all the eway up to 65535, and then continues past it starting at 0 again, continuing to count up
Pand seems that can exceed 0
Pso no positive value right?
Mi don't understand what you mean by no positive value
Mis there any way to invert the twist axis within the rhino ffb configurator?
Pyour z axis value only indicates negative value and zero
Pit is what I see
Mok, on the left side, yes i see what you mean
Myes, the z axis on the bottom left of the screen only goes from 0 to -4096
Mi can't seem to ever see a positive value out of it
Pisnt it strange that you cannot set negative value while your z axis already shows negative value 
Malso, buttons 10 and 17 are constantly being depressed
Phow many cycles there 0 to -4096
Mbut, when i turn the twist axis to the right, the button 17 turns off
Mbut nothing happens when i twist to the left
Mbutton 10 stays on the entire time
Pdo u have another grip?
Mlock to lock, i have a total of 7 cycles from -4096 to 0
Mno, i do not have any other grips
Pare u sure there is no wiring issue?
Mi was thinking of driving over to virpil usa and seeing if they had a test rig to try out the grip
Mwhat do you mean by a wiring issue, in the assembly of the rhino ?
Phow is it with original base
Pyes
Mi do not have an original base. the rhino is the only base i have. the rhino was bought full , brand new, fully assembled from vp force.
Mi just received it last week
Pah okay then. maybe no wiring problem. I guess
Mi have a 200mm extension on the rhino base. i will now remove the extension and try only the grip and see if the problem still exists
Pyes that’s the solution
Mthe extensions are incompatible ?
PI bet 0.1 cent it will work fine without extension
Mhow come? at first glance it appears to be only a PS/2 extension cable
Pcompatible of course but wiring problem can be there
Pjust test it, if it works okay, you can just open up extension rod and fix the cable wiring
Pit is quite simple.
Mwe are now plugged back in
Mwith only the grip to the base
Phow is it?
Mexact same, no change