Swapping plates

Is there a way to setup for different plates in 2.1. As beacon picks up the metal plate under the PEI sheet if you then use a different plate with thicker sticker the first layer differs. I use a PEI sheet but also a plate with FR4 stuck to the spring sheet that is thicker.
9 Replies
cgrr
cgrr2w ago
If you have the Beacon, the touch macro should take that into account.
triumphdave
triumphdaveOP2w ago
It’s the “should” part of that statement that worries me. I’ll try it tomorrow Well tried it and it dosesnt work, maybe i need to change a setting in the Beacon? I calibrated the Beacon with the plate with the thicker surface then changed to the plate with the thinner surface and it was printing in the air. I feel like i am missing some thing maybe skill issue!
03Julian04
03Julian042w ago
I have the same problem
triumphdave
triumphdaveOP2w ago
Have you found a solution?
03Julian04
03Julian042w ago
No description
03Julian04
03Julian042w ago
Maybe this one but I had no time till now to test it
triumphdave
triumphdaveOP2w ago
Oh ok I’ll have a look in the morning 👍🏻 Just tested this out and it works. Well spotted 👍🏻
03Julian04
03Julian042w ago
Have you recalibrated the beacon ? Like they write next to this Nice
triumphdave
triumphdaveOP2w ago
No I haven’t. I calibrated it yesterday to my thickest sheet and just put my thinner sheet on and all looks good.
Want results from more Discord servers?
Add your server