Configurate an unsupported Printer

As I failed to make 2.02 work with my modified Ender 6, because of the "must home first" Failure, I will try it with 2.1.
I used the VCorePro.cfg with 2.02, where I had to make several changes because of not having a Z_1 and Z_2 Stepper.
So my Question is: "Which supported Config is the best starting Point for the modified Ender6 (CoreXY, Stock Motors, Octopus 1.1, Dragon HF, LGX Lite, BL Touch)

Solution

The Question was for the basic kinematics. The other Data for Sensors e.tc. I have on Hand, as this maschine already ran on an older Klipper Fork (Desuu). I used the Voron V0-1 as Basis and with some slight modifications it is up and running.

Jump to solution