Vcore 4 400 IDEX Ratos STOP Button won't work

Hello,

i have a weird problem with RatOS and my Vcore4.
When i print and hit the stop button, the print stop for a short moment, the toolhead went to clean and after the the toolhead moves back to the print area and starts printing again. It starts acting weird. Hitting the stop button again, do the same. I can hit the stop button 10 times, but the print does not stop until finally the temperature auf the extruder hits the low value around 170°, then it finally stops.
I am using RatOS v2.1.0-RC3-26-g33980992, all updates made so far. I didn't touch any macros so far.
However if i hit the Emergency Stop print gets stopped, but with all the negative side effects e.g. clogging, firmware restart and so on.
The pause button works fine!

Any ideas how to fix that?

Best regards
sonypsx

Solution

Didn't found a solution for this, but did a new setup of RatOS from scratch!
Error is gone!

Jump to solution