**RatOS Configuration Repository**
After solving one problem by upgrading RatOS I now upgraded all "moduls". now I have a Problem, I can's solve. I tried both, hard and soft recovery
Solution:Jump to solution
```
ssh pi@ratos.local
cd ~/ratos-configurator
git fetch
git switch -f v2.1.x-deployment...
13 Replies
Solution
could you please write a little bit more what I should do? I'm not very experienced with klipper.
I tried to connect with putty, but I don't no Login-name and password.
Use putty
Connect to ratos.local
User is pi
Pw is raspberry (unless you changed it)
It will drop you to the shell where you can type the instructions TheTik kindly provided.
(Iām not familiar with your problem and his proposed solution)
What they said š
Thank You, whatever it did, it worked fine š
The lesson to learn is not do hard or soft recovery, it messes things up
I don't know wether it has anything to do with your solution, but now I have a new problem, that I didn't have before:
make sure your stepper drivers have cooling, and that the heatsinks are attached
I didn't have the problem before, it looks as if the motors get too high current, may be since i changed to "performance mode"
your drivers are complaining about getting too hot, make sure you have the correct driver type selected in the configurator, and that they are getting cooled.
š
I didn't close the electronics box yet so that the fan doesn't work yet. So I will do this work first ...
"performance mode" is normal current. We under volt them for setup so that they're less likely to destroy something if you messed up.
But drivers are expected to be actively cooled