Very low acceleration characteristics on V-Core 3.1 300
For some reason, on V-Core 3.1 I have quite low acceleration characteristics, although the graphs look as adequate as possible without unnecessary noise.
1 Reply
You could try to tension the belts a little more. But be careful, they overstretch easily.
I had mine overtensioned, which gave me 15.3k x / 6.3k y, but streched the belts slightly. After loosening the belts my Input shaper (mzv) now runs at 13.7 k x / 5.7 k y
Also the recommended accelerations for input shaper are to reduce artefacts like ringing. You can easily run travel, infill and inner walls at higher accelerations