Sugar Arrafel
RRCRat Rig Community [Unofficial]
•Created by Sugar Arrafel on 6/4/2025 in #ratos-support
How i can connect humidity sensor to CB1 with Manta M8Pv1.1
16 replies
RRCRat Rig Community [Unofficial]
•Created by Sugar Arrafel on 9/13/2023 in #fix-my-print
Overextrusion after internal top layers
52 replies
RRCRat Rig Community [Unofficial]
•Created by Sugar Arrafel on 4/20/2023 in #fix-my-print
Rough and overly rounded edges.
7 replies
RRCRat Rig Community [Unofficial]
•Created by Sugar Arrafel on 4/12/2023 in #ratos-support
Communication timeout during probing
I don't understand why this is happening.
Moreover, the connection with the toolboard is not lost, temperatures, and other information are transmitted correctly and without errors.
BTT EBB36 V1.2 , Manta m8p
USB cable - Baseus USB C SUPERVOOC 6.5A 2m, in principle a good cable with an internal mesh screen along the entire length. The first noname cable died after 6 hours of printing.
Maybe there is some script to check the stability of the connection to the toolboard?
43 replies
RRCRat Rig Community [Unofficial]
•Created by Sugar Arrafel on 4/4/2023 in #ratos-support
Strange behavior when building a table heightmap
So, my setup
VCore 3.1 500
Manta M8P v1.0,
TMC 5160 on each motor
Toolboard EBB36 v1.2
Rapido UHF
TriangleLabs Bltouch
8mm builplate
And ive strange behaviour when i'm trying to make a Height Map
He does not seem to take into account the bltouch offset, i.e. conditionally the nozzle is in the right place, but BLTouch in the standard configuration tried to make changes outside the field.
33 replies
RRCRat Rig Community [Unofficial]
•Created by Sugar Arrafel on 4/1/2023 in #ratos-support
Custom stepper motor configuration
68 replies