Nozzle play & stuck
I've got some problems with my T1:
Nozzle on T0 is firm, but T1 has a slight "wobble/play" to it, only ever so slightly but still, can I fix that somehow?
T1 will also frequently get "stuck" from (what I assume) retraction somehow, with a gentle push the filament pushes through and extrudes fine again.. I assume this is related with the "wobble".
ANY HELP MUCH APPRECIATED! 🙏
2 Replies
Hi Cookiez, I had the same problem with my hybrid 300x300 nozzle. My stupid move was that the nozzle fell into the bed, and the tube between the cold and hot zones broke off. After a while, the filament came out from between these parts. Unfortunately, I had to replace the entire hot end. This is because the tube is fixed at one end and you can't replace it.
