Odd sound after replacing hotend.
So I replaced hotend and had to replace the front bracket so undid my belts. Now I hear odd noise. Loosening or tightening doesn't make a difference.
6 Replies
Turn the grub screw away from the flat spot of the hybrid motor shafts.
@Hergen66 So tightening it on a round spot?
Yes.
Yes
That is the opposite of what is usually recommended, should tighten against the flat. What is your reasoning for tightening against the round section?
Thats what i did to get rid of that clicky clack noise. Same as you can watch here https://youtu.be/so9oqJyirKY?si=F6CiDmxi3aVJHrH1 on the Vez3d channel (vzbot motor sync). Give it a shot.
Vez3D
YouTube
Sync your AWD motors. New method
Giving you a little and quick way to sync your printer's motors.
Printers:
-full Vz235 printer kit: https://s.click.aliexpress.com/e/_Dld...
-Full Vz330 printer kit: https://s.click.aliexpress.com/e/_DkF...
Printer Parts:
- Waterpump kit I use here: https://s.click.aliexpress.com/e/_DEt...
-240mm Radiator: https://s.click.aliexpress.com/e/_DFO...
Watching that vid now
Followed the video. While not 100% I would say that it fixed clicky clack by 98%. Thanks for the assist.