Pi undervolted?
Suddenly getting these messages recently. Doesn't seem to affect any of the prints so far though. Anybody know what could cause this?
4 Replies
If you're powering the Pi via the standard method of using +5V from the Octopus board, it can happen. The Octpus board's 5V regulator can't quite provide enough power for the Pi and all USB peripherals, especially through the thin wires. I think a lo t of people use a separate 5V power supply for the Pi.
Thanks, sounds like I have to as well indeed
I am seeing the same messages and mine also appeared what I thought was suddenly, but actually started happening after letting RatOS update to RC3. Are you on RC2 or RC3 by chance?
i run my pi on an official pi power supply and havent had issues with all of the USBs. the camera in the near future may change that though.