V-Core4 - Error when trying to print
Hi,
Been finishing off the provisioning steps and was at the part where I could try just go and print, did a few things, had an issue with extruder temp but that was loose wiring (fixed now), but now I'm getting an error whenever I try print anything.
Error:
- Error evaluating 'gcode_macro START_PRINT:gcode': TypeError: bad operand type for abs(): 'Undefined'
Have tried PrusaSlicer and a clean version of OrcaSlicer to re-export. Original files I had printed for skew etc are also not working so assuming its printer related rather than slicer related.
Update manager shows everything up to date.
4 Replies
The only other person I've seen with that kind of error was here:
https://discord.com/channels/582187371529764864/1405918167624187945/1405939693937234112
Thanks, yes I found that first but didn't seem to help much. I have gone to configurator, skipped to the end and allowed the config to reset the printer.cfg file (I made a backup). Printer restarted. I have then added in a few things previously required then re-ran beacon calibrate which did a full run again. Same issue.
Very strange :/
Ok, so after going through config files and looking at logs etc, it was to do with the VAOC config. When I re-ran the VAOC initial set up, config, then that seemed to fix. No idea why it happened in the first place, maybe I reset something but wanted to post in case others hit this issue.