RRC[

Rat Rig Community [Unofficial]•4d ago

asgarda_

Vcore4 500 IDEX

hey everyone, i am trying to get a perfect first layer

as far as i understand when using the beacon it should be straightforward to get a perfect first layer

What i currently do is heat soak for half an hour at 150 degrees for the hotend and 65 degrees for bed temp
(temperature i use to print with)

my height map looks like a sine wave (see attached screenshot, its made with the contact method)

Im mainly seeing issues in the front left part of the bed where it is red in the screenshot

i do see the z motors move when printing so im guessing it's adjusting for the difference in z height


any thoughts/ideas on how i can resolve this