Hello,
I recently upgraded my I'DEX 500 to 4.1 and installed the new RC4 also. I have discovered some bugs and I want to share my thoughts about the default settings.
list of bugs I found:
* if the runout sensor of t1 gets triggered, the toolhead t0 moves to the right side of the printer close to t1. this is not the correct parking position for t1. is there a way how to change this? you maybe have to look into the macros. maybe there is a bug or so.
* Load/Unload macro on Klipperscreen are not working
List of improvements:
* It would be good that the printer is not continuing on its own if the Runout sensor recognises filament. triggering the #load macro is ok, but continue the print directly afterwards could lead to potential danger or could cause unneccessary issues. Consider the load procedure faild and the filament is stuck inside the extruder. then the macro continues the print but the toolhead was not ready to do so. you still have your fingers inside the printer and this could cause injuries.
therefore: please consider to deactivate this behaviour on default. always continue the print by let the customer press the button.
* could you please enable the network manager for the klipper screen? then you can easily find out the IP adress of the printer and you can change the network which could make it a bit easier if you have to change your router or your location.