not sure what changed
I reflashed my vcore got it back up and running my problems in the video
7 Replies
With Rat-OS 2.x the prime location changed, so that's normal.
As far as printing off the bed, did you do your z calibration?
xenial-black•16mo ago
How do I go about doing the z calibration? I’ve never figured that part out I’ve always just adjusted the zoffset but I thought this one was a little much
Configuring RatOS | RatOS
RatOS only needs minimal configuration to work, but comes with a lot of optional functionality that you can enable manually.
xenial-black•16mo ago
Ok so I did the home all then did the g0 command and it homes z then sets to 15 mm now it’s safe to say I need to lower my z offset and save it when I get paper to drag?
Why are you doing a g0? No where in the instructions does it tell you to do that
xenial-black•16mo ago
Hehe I stand corrected. I always do the
probe_calibrate as it is much easier