The circuit has a buzzer, an LED, 1 button (which is like a sensor), 1 button which is like a reset, an LCD screen, a switch and a Potentiometer. The project has to work as follows, as soon as I start simulating the project (which will be in Tinkercad) the word count and the zero below will appear on the LCD screen, as soon as I press the button that serves as a sensor, the counter it will show 1, ring the buzzer and turn on the LED at the same time and so on continuously, if for example I press the button 5 times, each time it is pressed it will appear on the LCD, depending on the time that the potentiometer marks and the buzzer and LED turn on together. The Potentiometer will serve as time in seconds to carry out the count, so for example if the Potentiometer has a delay of 4000 and I press the button, the counter will only show on the LCD after 4 seconds and the buzzer and the LED will also ring (the Potentiometer goes from 0 to 4000). When I press the switch down, it will show the Potentiometer information on the screen with the word Potentiometer at the top and the count in seconds below and when I move it up the switch will show the counter on the screen again. The other button will reset the counter
F
N
K
M
A
G
T
K
M
Z
M
N
The Upcoming Event :