beats me .... I know hardware but the settings are a complete mystery to me...I dont even know what
beats me .... I know hardware but the settings are a complete mystery to me...I dont even know what to set my rhino to in fs2020 or dcs.
HThere is a section with HPG H145 and afcs
Sthats software. the hardware part of the manual deals with the vertically-oriented turnkey rhino
HSays for collective spring force is required
HThank you Tony
Sright. thats how it pushes the collective around/locks in place. has nothing to do with balancing
HOkay I see. I'm fire up 2020 and see if it will work
Sdid you calibrate and are both numbers between 0-4096
HYeah I followed this per your direction
HI have this message "please enable telemffb_control_axes in your config. I don't see that
SAxis Control
HIs that in telemffb or the vp force?
Stelemffb
HHave it enabled and still have an error
Sthats the joystick
HI don't have anything connected to the pc besides the collective motor and my mouse
Sgo to telemffb system options and tell it this device is a collective
HI must be blind
HFound it
H
HDo I need to pit the number in there 2055?
Sdo you have a vpforce joystick also? you should change the name & number of the collective in vpf configurator first
HI have one coming yes and anti torque pedals. I'll change the name and give it a unique number
Sheres my setup
HOkay I have a green on the msfs and I'm in the heli but collective is still sitting in the center and not responding to my input
Sall bindings in msfs removed? sorry its been a while since i was in a hpg
HCorrect all bindings removed
HI double checked in vp config and my axis moves
Sset up force trim buttons? (reset is optional)
HThis I didn't do
HI have to hook up the grip
Soh sorry that was joystick page, collective page is like this and apparently i have no button set up
Si think you also have to bind the trim release in msfs (or the hpg app) to the same button. and beep trim also
HOkay grip is hooked up and I went into force trim and clicked the button and it didn't register. Supposed to be button 36
HDo I have to config or turn anything on in the vp force configurator?
Syeah, check configurator for grip type and button mapping setup
HI set as generic grip, went into hard force to bind click the button and nothing happens
Sbeats me, thats a walmis question
HYeah I don't have a grip physically plugged into the control board. It's a separate device
HI think it may be to be loop back then bound in the sim
Sah ok then it should be possible thru the loopback, i just dont know anything about it
HNeither do I loln
HI'm dumb, you have to run the loopback exe file.
HI have the button mapped, sees it but the trim release isn't working
Ssprings cranked up? gain map set?
H
Syou have everything zero'd on configurator
HI didn't think I need global if the effects are set? Lol
HHow did you get yours in dark mode?
Seffect times 0 is 0
Sand im not sure on the dark- one of the updates it just started that way. might read windows setting
