if anyone might be looking for one - I am selling this TM TQS F16 MissionPack. Hardly any traces of

if anyone might be looking for one - I am selling this TM TQS F16 MissionPack. Hardly any traces of use. Original Packaging and invoice from 23.12. Asking 300,-
I hope its fine that i post that here!

SSR-F_Winger_[73]_David if anyone might be looking for one - I am selling this TM TQS F16 MissionPack. H...

f14billy•12/20/24, 3:16 PM

Sent you a PM

Rocco Thamanoidis•12/20/24, 6:01 PM

Any airbus pilot can tell us, if the sidestick gets lighter/heavier with changing airspeed? Thnx

Bozo VFA-86•12/20/24, 10:34 PM

Not that I noticed...very much not a force feedback type feel...I'll check the manual.

RRocco Thamanoidis Any airbus pilot can tell us, if the sidestick gets lighter/heavier with changin...

Boggy•12/20/24, 10:37 PM

It doesn't. It always feels the same.

TrigaNZ•12/20/24, 10:38 PM

Roll force is lighter than pitch force.

RRocco Thamanoidis Any airbus pilot can tell us, if the sidestick gets lighter/heavier with changin...

Boggy•12/20/24, 10:39 PM

When you're flight control laws blend into normal law after take off the pitch becomes a G load demand and roll becomes a roll rate demand.

Kite•12/20/24, 10:54 PM

Mentour Pilot on YouTube said Aibus are developing it to get both synchronized movement between the sticks and ffb.

Kite•12/20/24, 10:54 PM

I wonder if they will try a side yoke as well?

TTrigaNZ Roll force is lighter than pitch force.

Horizon•12/20/24, 11:51 PM

And roll has asymetric force, needs more force inwards than outwards

Stryker990•12/21/24, 12:55 AM

Still wish somebody had a rhino Profil to simulate an airbus sidestick :crycat:

Number481•12/21/24, 1:38 AM

looking at the video above.. just seems like fairly light spring force and a shit ton of damper?

AndyHill•12/21/24, 2:23 AM

iirc the stick is supposed to go stiff when you engage autopilot

AndyHill•12/21/24, 2:25 AM

the airbus sidestick

HHorizon And roll has asymetric force, needs more force inwards than outwards

Boggy•12/21/24, 9:21 AM

What? No, it doesn't. That's probably more likely to do with our musculature and how it's easier to make an inward movement compared to outward.

AAndyHill iirc the stick is supposed to go stiff when you engage autopilot

Boggy•12/21/24, 9:23 AM

Yes, that's true. The rudder pedals stiffen up on an autoland with rollout guidance too iirc (it's been a while since I checked that ). In fact , I think they stiffen up when you engage the autopilot. I never have any rudder input when I engage the autopilot so it's not something I've noticed.

BBoggy What? No, it doesn't. That's probably more likely to do with our musculature and...

Horizon•12/21/24, 9:27 AM

The exactly why they do it, needs more force inward as it's easier to pull inward and vice versa

HHorizon The exactly why they do it, needs more force inward as it's easier to pull inwar...

Boggy•12/21/24, 9:30 AM

Really? I've never noticed that. I'll pay closer attention to that next time I do the flt control check.

Horizon•12/21/24, 9:55 AM

What I could find:

Breakout force: 1.1 pounds

Pitch: Fore and aft. +/- 16 degrees 22.5 pounds

Roll: Outboard 20 degrees 5.6 pounds.

Roll: Inboard 20 degrees 7.8 pounds.

HHorizon What I could find: Breakout force: 1.1 pounds Pitch: Fore and aft. +/- 16 degr...

Boggy•12/21/24, 12:27 PM

Oh wow, that must be in some kind of maintenance manual. It's not in the FCOM, is it?

AndyHill•12/21/24, 1:17 PM

so are we getting stiff sticks in our buses at some point?

Red Magic•12/21/24, 2:13 PM

I noticed when in the 64 and not flying, my stick doesn't move. I wonder, how possible is it that when the stick is folded (controls handed off to other pilot), the ingame cyclic will effect the position of the Rhino?

BBoggy Really? I've never noticed that. I'll pay closer attention to that next time I d...

Arno•12/21/24, 5:27 PM

Yes it's like that. Try to deflect with the "wrong" hand, and you'll notice.

VVPforceBot :package: 🇺🇸 **RHINO #0841** Has Shipped!

Eisotope•12/22/24, 12:46 AM

#0841 is being enjoyed. Thank you!

OldmateHC•12/22/24, 2:01 AM

Oooh yehhhh 69 rhinos to go

AndyHill•12/22/24, 2:44 AM

69 orders of rhino on the wall, 69 orders of rhino

Mike T•12/22/24, 4:03 AM

Hi all…….just trying to make sense of the VPF control board……in this pic posted below…….can someone answer the 2 questions I have? Ta

TheAmazinGreat•12/22/24, 5:17 AM

Joystick axis - yes
Other plug - 🧰support

📃general

TTheAmazinGreat Joystick axis - yes Other plug - https://discord.com/channels/965234441511383080...

TheAmazinGreat•12/22/24, 5:19 AM

@Mike T

Mike T•12/22/24, 6:59 AM

Thanks <@TheAmazinGreat>

SR-F_Winger_[73]_DavidOP•12/22/24, 9:52 AM

Reminder for everyone that might still BE looking for a Xmas Present. One Monster Rhino Base ready to put Motors in is available. PM for Details:

SR-F_Winger_[73]_DavidOP•12/22/24, 9:52 AM

Falcoblu•12/24/24, 4:16 PM

The most appreciated Christmas present ever received, thank you very much Walmis

EAF51_Jimmi•12/24/24, 5:29 PM

Hi everybody! Just got a Rhino from a teammate and i'm struggling to set up the software properly. I red the manual but there are tons of options and it's overwhelming... I fly mainly warbrids. Before the rhino i had an arduino controlling a motorized pulley that stiffened or loosed the joy depending on airspeed (dcsbios telemetry). The joy was loose on the ground and on top of a loop or hammerhead and very heavy in a dive. So far i've played with many settings especially the new g-forces in vpforce telem but for my geelings the delta between the minimum and maximum forces is too small.. In particular i feel a light stick before the take off run... but once in flight stick gets heavy and stay heavy even on top of a hammerhead with propeller on idle and less than 50mph... Without air hitting control surfaces my understanding is that they should be light as while on the ground... Any tips on were to start? Can someone share their warbirds profiles? Ty in advance and merry Christmas and great flights!

EEAF51_Jimmi Hi everybody! Just got a Rhino from a teammate and i'm struggling to set up the ...

f14billy•12/24/24, 5:54 PM

Are you using telemffb? Or just the dcs force feedback effects?

Ff14billy Are you using telemffb? Or just the dcs force feedback effects?

EAF51_Jimmi•12/24/24, 6:06 PM

tried both!

f14billy•12/24/24, 6:09 PM

You may want to post pictures of your configuration to see if maybe something there needs to be adjusted

f14billy•12/24/24, 6:09 PM

The tabs in the vpfprce configurator

NIKO_BG•12/25/24, 7:51 AM

Merry Christmas

SR-F_Winger_[73]_DavidOP•12/25/24, 10:32 AM

Merry Xmas Folks. Have a good time

G. R. Cooper•12/25/24, 4:27 PM

Waiting for a new mount - state of the art 1995 v 2025:

GG. R. Cooper Waiting for a new mount - state of the art 1995 v 2025:

corbu1•12/25/24, 4:46 PM

Back in the 90‘s I had the full set. TM stick, throttle and pedals. Now the memories come up again

Sudeebare•12/25/24, 5:56 PM

How strong should cyclic control stick forces be set in the AH-64D and Huey to best simulate RL?

Fr4Ged•12/25/24, 6:28 PM

I mean I am pretty sure you don't really have any forces in the stick of at least the Apache. So basically just the force trim and maybe a slight rumble

KangaRooskie•12/25/24, 8:03 PM

Hi folks! Been on the list now for a while and am curious about the product. I currently use a VKB gunfighter base with a MCG-U stick, using a 100/200mm extension depending on the plane. Has anyone here made the jump from my setup over to the Rhino FFB?

KangaRooskie•12/25/24, 8:05 PM

From what I understand, you can adjust the feedback pretty easily between different airframes. How much of a hassle is it to switch between different profiles? Let’s say I like flying 200mm on warbirds but then switch to 100mm for a jet, and a different profile for helos. Is this all doable?

KangaRooskie•12/25/24, 8:05 PM

Finally, what software controls the grip config? Would I still use VKB’s software for the grip itself, and Rhino for the base?

KangaRooskie•12/25/24, 8:08 PM

Oh, also, does anyone here desk-mount their base? Is that doable?

KKangaRooskie From what I understand, you can adjust the feedback pretty easily between differ...

Fierce_Fire•12/25/24, 8:10 PM

I believe you can configure the program to load different profiles based on the aircraft, so the only "hassle" would be to switch the extensions. This isn't that bad, as the vkb adapter has an external wire so you only have to swap the physical connection. You are also correct that you keep the vkb software for the grip.

Fierce_Fire•12/25/24, 8:11 PM

Lastly, there have been a few that desk mounted, but they made a slight modification to support the mount from the floor as well. You can find some examples here, use the discord search to make it easier.

FFierce_Fire Lastly, there have been a few that desk mounted, but they made a slight modifica...

KangaRooskie•12/25/24, 8:21 PM

Nice, thanks!

if anyone might be looking for one - I am selling this TM TQS F16 MissionPack. Hardly any traces of

Similar Threads