Otherwise it will try to come to the center but fall short due to the friction.
Otherwise it will try to come to the center but fall short due to the friction.
HI just spoke to the engineer and nope no trim release on this heli
HThe reset on the cyclic only clears the acknowledgements on the mfd
FOne less thing to worry about haha
HWith that being said then adaptive re-entering isn't needed am I correct?
FI don't think so
FSince you aren't changing the center and the sim is never trying to center it there
HOkay perfect, really appreciate the help! I'm going to try in sim and see if it's okay
FIt should be much much better now!
FBy the way. When you test the autopilot. If it works by moving the center... You will need adaptive recentering on.
FFor jets in DCS that's how the autopilot works. Moving the center and the stick follows it.
FYou can test that by having the configurator on as the autopilot runs. If you see the center circle moving. That's how it handles it.
HHmm. I enabled sticky but even after I apply trim release and let go it starts to move on its own
FSame issue you had before? With the slowly sliding to the side?
HYep same one. No issue when the sim is not running
FCan you try running the sim without telemffb?
FAnd see if the issue is still there.
HWas thinking the same thing
FIf the issue is telemffb then it should be easier to troubleshoot than if it's sim related.
HI don't have any axis bound in fs2020 so nothing happens in the cockpit but the trim release works as intended
HLike in the sim nothing moves but I have loop back on and mapped
HNo issues with collective by the way. That works perfect
FThen I'd say map the axis and test without telemffb.
FOnce you have all that running. Try telemffb and if the issue is still there. Some settings may need to be changed or the developers may be able to help you here.
HI mapped the axis and force trim works without issue. No weird deviations
FPerfect. Now telemffb and let's see what it does.
FMaybe telemffb wanted the axis to be mapped? 
HIt shouldn't because in the manual it tells us not to map it specifically for the h145 because axis control is enabled
FOh ok well if that's how it's supposed to work and you have that issue hopefully the developers can help. As far as the configurator setup I think you are all set.
FJust make a new video explaining the issue and post your configurator settings for reference.
HThe second I started telemffb the stick starts to deviate
H@Number481 help lol
FLol almost there!
HI'm going to turn off all effects except for axis control and force trim in telemffb. Maybe getting dirty data
FThe more information you can get about the issue the better.
FIf you can pinpoint to which setting is causing it even better
HAgreed especially if it helps others
FJust curious.. what are your current spring values? Not balance spring. I saw that you had them at 2% and are they sticky?
HSpring is 100% in global and adaptive re-entering is 20%
HDamper 20, inertia 10, friction 20, static is 5%
FThose percentages aren't for adaptive recentering. Those are spring values per axis.
FAnd are they sticky?
FBasically how much force for the stick to return to center. In your case you don't want to use it.
HI had sticky off. I just unplugged the collective so I can run the one instance and see if there is anything happening
FSo leave spring unchecked.
HWhat do mean force? Where is the value?
FCan you post your configurator values?
FA screenshot.
H
FOk so see under adaptive recentering.
FYou have set spring force or 20% to return to center. Since you don't want the stick to return to center. Disable that spring check.