Gantry Twist very high
Hello, I performed my Beacon calibration and got a very high gantry twist result. I adjusted my gantry belts and got both sides touching at the same time with no play. I ran the beacon calibration again and the values got worse. Are these values possible or is something else going on? They seem way higher than what would be possible. Where do I go from here? Thanks
3 Replies
I thought gantry twist was solved with adjusting the beams, not the belts
Something weird going on in the front right sector, 206um is WAY out. All the others look quite normal.
What does your bed mesh look like?
@TheTik and I saw a large dip in that area, but assumed it was the sensor going over the edge of the bed since nothing visually was off.
