LeoManola
RRCRat Rig Community [Unofficial]
•Created by LeoManola on 5/30/2025 in #fix-my-printer
How to enable nozzle wipe
I have the two felt nozzle wipe pads on the left and right arm of my machine but they are not being used. I did some searching in the discord and found a few threads and copied "variable_has_front_arm_nozzle_wiper: True" to my "[gcode_macro RatOS]" section. They are still not being used. I do not see any other threads with solutions to this. Could someone please let me know what else I need to enable? Thank you.
5 replies
RRCRat Rig Community [Unofficial]
•Created by LeoManola on 5/30/2025 in #fix-my-printer
Large nozzle extrusion issue
6 replies
RRCRat Rig Community [Unofficial]
•Created by LeoManola on 5/26/2025 in #fix-my-printer
Beacon lower than nozzle
11 replies
RRCRat Rig Community [Unofficial]
•Created by LeoManola on 5/21/2025 in #fix-my-printer
Gantry Twist very high
6 replies
RRCRat Rig Community [Unofficial]
•Created by LeoManola on 5/20/2025 in #fix-my-printer
Electronics fan not turning on
13 replies
RRCRat Rig Community [Unofficial]
•Created by LeoManola on 5/14/2025 in #fix-my-printer
Bed Heater Wiring Confusion
18 replies